The geotechnical documents and studies located here are intended to help establish stable and economically feasible mining practices that take into account the safety of personnel, equipment, infrastructure and the environment.
The following form applies to any geotechnical incident classified as a dangerous occurrence or to any geotechnical incident that requires changes to an existing standard operating procedure or the creation of a site-specific safe work plan. In addition, any multi-bench pit slope failure, spoil failure resulting in full loss of the crest berm, or dam embankment instability (regardless of size) is to be documented on this form. This form is not intended for single bench failures fully captured by catchment berms or for "silver" failures on spoils not resulting in a dangerous occurrence. The "Advice of Geotechnical Incident" form should be submitted to the regional inspector of mines and the Manager, Geotechnical Engineering as soon as practical after the incident.
In British Columbia, all dams located on mine sites are regulated under Part 10 of the Health, Safety and Reclamation Code for Mines in British Columbia, as established under the Mines Act. Dams on mine sites that impound non-contact water may also require a water license under the Water Sustainability Act and may also be regulated under the BC Dam Safety Regulation.
References relating to mining dams as follows:
Under Part 10.5.3 of the Health, Safety and Reclamation Code for Mines in British Columbia, permitted mines are required to submit annual Dam Safety Inspections (DSIs).
The geotechnical documents located here were developed by the British Columbia Mine Waste Rock Pile Research Committee, and form part of the "Interim Guidelines" referenced in Part 10 of the Health, Safety and Reclamation Code for Mines in British Columbia.